Dual station Taber wear resistance tester

Dual station Taber wear resistance tester

Product Introduction:

The Taber wear tester evaluates the wear resistance of its products through wear tests, such as measuring their quality loss, thickness loss, and light transmittance. The method is to use a standard cutting tool to cut the test piece, use a specified model of grinding wheel, and load a certain weight to wear it. After reaching the specified number of revolutions, take out the test piece and observe the condition of the test piece after grinding or the difference in weight between the test piece before and after the test.

Applicable scope:

Mainly used for wear resistance testing of luggage, carpets, cardboard, clothing, glass, plastic coatings, tiles, metal coatings, paint, varnish, decorative films, high-pressure films, plastics, textiles, elastic floor mats, traffic paints, anodized layers, blankets, electronic components, decorative panels, wax, labels, leather covers, dental materials, automotive interior decorations, resins, furniture, etc.

Compliant with standards:

DIN-53754,53799,53109,52347 Inspection of plastics; Measuring wear using the grinding wheel method

TAPPI-T476 Rubber Rolling Wear Test Method

ASTM-D1044 Test Method for Surface Wear and Corrosion Resistance of Transparent Plastics

ASTM D3884 Standard Test Method for Wear Resistance of Textiles

ISO-5470 Determination of wear resistance of rubber or plastic coated fabrics

Operation steps:

Before the experiment, the instrument needs to be connected to the power supply and the exhaust port needs to be connected to a vacuum cleaner

Accessories and other instruments: a pair of standard grinding wheels, double-sided adhesive (hard), fine sandpaper (for calibration). According to different standard requirements, it is necessary to prepare a 0.1mg precision balance, fabric strength machine, appearance evaluation lightbox, etc. to evaluate the test results.

Sample: Cut to around 110mm, leaving a hole of 8mm in the center. If it is necessary to compare the weight changes of the sample before and after, the original weight of the sample needs to be weighed in advance (if the sample is made of fabric, it needs to be fixed with double-sided adhesive, and the standard double-sided adhesive needs to be applied before removing the outer layer of the sticker and weighing its total weight); To compare the changes in strength before and after the test, the original strength should be tested before the test; Comparing other performance indicators such as haze requires corresponding testing to determine the original parameters before the experiment. The sample needs to be pre wetted for at least 8 hours.

Speed regulation: After powering on, start the instrument with both arms raised, and adjust the speed regulation knob to the desired speed according to the digital display

Prev: Automobile sealing strip wear-resistant testing machine