Tempered glass abrasion tester Glass abrasion tester

Glass Abrasion Tester is used to test the scratch resistance and scratch resistance of mobile phone screen, tempered glass and other glass products, set by counter. frictions, the governor controls the operating speed of the friction head to meet the actual testing needs of customers.

Product Introduction

Main Purpose :
Glass Abrasion Tester is used to test the scratch resistance and scratch resistance of mobile phone screens, tempered glass and other glass products. The number of frictions is fixed, and the governor controls the operating speed of the friction head to meet the actual testing needs of customers.
Test Principle:
During the test, steel wool cloth is installed on the friction head with a size of 10mm*10mm, and the adjustable weight can reduce the pressureload of the friction head and the glass After rubbing, after the experiment, take the sample down to evaluate the resistance to scratches and scratches.

Tester for abrasion resistance of glassTechnical parameters:
1. Test module: three stations Glass friction module;
2. Reciprocating platform movement distance: 50±5mm adjustable;
3. Reciprocating platform movement speed: 0-120rpm adjustable;
4. Friction test load: 10N/station;
5 Power supply: AC 220V 50HZ;
6. Dimensions: 700mm*300mm*270mm (L*W*H);
7. Weight: 51 kg;
br />8. Friction head: the size is 10mm*10mm, which is in contact with the sample with the steel wool instrument.
Main description:
1. Reset button: clear the sound and real-time laps of the timer;
2. Start button: after the speed control switch is turned on Used to start the engine;
3. Governorneur: used to adjust the running speed of the motor;
4. Adjustable weight: used to adjust the load applied to the friction head;
5. Mode switch: pull the top for continuous automatic operation mode. In this mode, after the machine has passed through the set number of times, the machine keeps rubbing and the toner stops after turning off the toner power supply; pull it at the bottom for the number of times mode, here In this mode, the motor will stop rotating after the device has run the set number of times.

Preparation experiment:
1. Take a sample with a size of 200mm*150mm from the whole sample, or cut 3 samples of 100mm*50mm;
2. Adjust the friction head and test piece by adjusting the screw on the friction head. The gap between the samples ensures a tight fit on the contact surface.
Test method:
1. Place the cut sample on the sample clamping platform and clamp;
2. Confirm the weight and make sure the friction head and sample are in full contact and tighten the device;
3. Turn on the machine and select the required test mode (two frequency modes and continuous operation);
4. Set the desired friction The number of times, select the speed to run;
5. Turn on the governor switch, press the start button, the equipment starts running;
6. After the test is completed, record the surface friction of the sample and make relevant assessments.
Safety instructions:
Users should take all reasonable safety precautions and if in doubt seek professional advice before use;
This instrument is designed for use by professionally trained personnel in a controlled environment;
The instrument is intendedfor use in residential, commercial and light industrial environments, in accordance with standard EN 50081-1;
The company is not responsible for any unauthorized responsibility for modifications to this device.

Prev: taber5155 wear test machine / taber wear tester