Taber Linear Abrasion Meter Sample Installation

When the Taber linear abrasion meter is used for testing, since the sizes and shapes of abrasion test materials are diverse, appropriate sample support should be determined to ensure that the sample is fixed in the appropriate position. If the product is modified or moved during testing, inconsistent wear marks may become more frequent, which will compromise the test results.
It is recommended that the specimen be tested as close to the splined shaft as possible. This reduces the moment arm of the splined shaft, which in turn will minimize the tendency of the splined shaft to flex when the test fixture is dragged across the specimen. To reproduce test results, it is important that the specimen cannot be hindered by the movement of the test accessories and that the specimen is positioned the same for each test and mounting method.

Unive benchT-slot bench:
The universal T-slot bench provides a large testing surface and accommodates up to 5/16 inch eats. and 3/8 inch T-slot configuration clip. The universal T-slot table has two T-slot configuration clamps, which will ensure the fixing of the flattest samples, as well as other shaped products. There are also spacer strips that can be used to raise the surface approximately 2 inches. It is recommended to minimize splined shaft deflection when testing flat samples.
The optional sample holding plate can be used with the universal T-slot stage. Secure flat, semi-flexible or flexible samples with the wide slot sample clamp kit.
Lightweight flexible materials such as textiles can be attached to the universal T-slot plate using the mounting platesample optional. An 8 mm diameter rod is placed under the specimen to provide pretension and reduce movement of the specimen. The sample holding plate has an opening of 11mm x 140mm.
When testing the data card with the magnetic stripe wear kit sample clamp, it is recommended to use a universal T.ble slot ta. This test stand features recessed areas to hold data cards securely in place. Semi-circular finger holes make it easy to remove the data card after testing is completed.
Wire nuts ensure that wire or cable samples are held in place during testing. For its use, the cylindrical object is designed to be at least 3.5 inches long and between 0.037 and 0.098 inches in diameter. The support portion includes a raised area with a 0.080 radius cutout for placing the sample in the support.Secure it to the universal T-slot table with two T-slot clips.
Universal sample stage:
The universal sample stage is a holder Multifunctional sample for the Taber linear abrasion meter, which includes three interchangeable chucks. The standard vise head features nylon jaws that provide a \"soft grip\" and open approximately 57mm. The large opening vise head jaws are designed to open approximately 150mm of ribs. The jaws of the neoprene pad have a good grip and when inverted will provide a \"V\" grip for holding cylindrical objects. The third interchangeable head is the clamp head, which features a flat 135 diameter surface.
The universal sample stage features a low profile mounting, including a \"split ball\" design. This allows you to tilt, turn or rotatethe head of the sample positioning vice. A universal sample stage is mounted on the bottom of the linear grinding wheel to ensure it does not move during testing.
For more information about Taber linear abrasion meter, you can directly search Standard Group (Hong Kong) Co., Ltd. or call directly 021 678 or 01892 for consultation.

Prev: Manufacturer of Reduced Weight Fabric Tear Testers Shares Impact of Finishing Process on Physical and Mechanical Properties