Welcome to the Qinsun Instruments Co., LTD! Set to the home page | Collect this site
The service hotline

Search


Related Articles

Product Photo

Contact Us

Qinsun Instruments Co., LTD!
Address:NO.258 Banting Road., Jiuting Town, Songjiang District, Shanghai
Tel:021-67801892
Phone:13671843966
E-mail:info@standard-groups.com
Web:http://www.qinsun-lab.com

Your location: Home > Related Articles > Operation steps of T115 automotive interior material fusion tester

Operation steps of T115 automotive interior material fusion tester

Author:QINSUN Released in:2023-12 Click:70

The T115 automobile interior material melting tester performs 30 kW/m2 thermal radiation on the sample through a top radiant heat source, thereby triggering the release of gas, burning the sample to produce melted droplets and testing the melting and dripping of thermal radiation. automotive interior materials. This is a test equipment independently developed and produced by our company, Qisnun Precision Mechanical and Electrical Technology Co., Ltd., with high performance-price ratio and comprehensive after-sales service.

Complies with standards:

NF P92-505 flame retardant test standard, EU 95/28/CE automotive interior materials fire test standard

Operation steps:

1. First: prepare the accessories and test samples;

2. Turn on the power switch of the instrument and turn on the safety doorrity of the instrument;

3. Place the cotton under the support and place the height block on the rack;

4. Press the [Up] button and [Down] buttons on the panel. Make the distance between the sample on the rack and the radiation surface 30mm;

5. Place the sample on top of the holder;

6. Press the [Light] button on the panel to turn on the lighting;

7. Move the electric heater to a location where the sample cannot be radiated;

8. Then press the [Heating] button;

9. At the same time, adjust the power by turning the knob;

10. When the temperature reaches a certain level, the radiant lamp is heated to the set temperature;

11. Return the electric heater to the sample position;

12. Press the [Reset] and [Heating] buttons to start automatic synchronization;

13. If the materialmelts and deforms, keep the height of the electric heater at 30mm;

14. If the material begins to burn, push the electric heater aside for three seconds;

15. Wait for the flame to go out, then return it to its original location;

16. Repeat the same operation, and finally see if the droplets burn as they fall, or if the cotton catches fire;

17. At the end of the test, turn off the instrument and remove the sample for analysis and comparison;

18. Evaluate the melting performance of the material based on the irradiation of the sample with the specified radiant heat source and the melting state of the sample.

Shanghai Fanbiao Textile Testing Technology Co., Ltd., as an enterprise integrating R&D, manufacturing, sales, training and service, is committed to putting more testing instruments on the market and to provide long-term textiles, leather, instruments oftest for combustion, automobile interior materials, environmental climate aging, masks and protective clothing, etc. can also be customized to meet non-standard requirements. Targeted testing can be carried out according to customer requirements before purchase to ensure that the purchased instruments are suitable.

Prev:

Next: