F243 Needle Flame Tester Operation Steps

The F243 needle flame tester is a testing equipment independently developed and produced by our company, Shanghai Fanbiao Textile Testing Technology Co., Ltd. It is cost-effective and suitable for testing components and parts of electronic and electrical products, household appliances. , etc., such as: wiring boards, juicer switch, rice cooker socket. The small flame generated inside the product under fault conditions is simulated and the fire risk is evaluated using simulation technology.

Reference standards:

IEC884-1 “Electrical charging cabinet for standard electrical accessories”

GB2099.1-2008 “Domestic and similar plugs and sockets Part 1: General requirements\"

IEC335-91 \"Safety of household and similar appliances. Part 1: General requirements\"

GB4706.1-2005 \"Safety of household and similar appliances, part 1 General requirements\"

GB5169.5-2008 \"Fire Hazard Test for Electrical and Electronic Products - Flame-Needle Test Flame Test Method\"

UL1694 \"Combustion Test Method\"

Operation steps:

First: prepare the accessories and test samples;

Open the heat-resistant glass observation window;

Unscrew the tightening nut;

Install the test sample on the clamp;

Tighten the screws to secure the sample;

Start and turn on;

Adjust and measure the height of the flame;

Adjust the torch angle;

Push the torch forward along the track;

The needle burner ignites the sample at a 45 degree angle;

Observe the combustion conditions of the sample and start the ignition timing;

Obtain test data and save it for viewing;

At the endn the test, turn off the instrument;

By observing the ignition state of the sample and measuring the relevant indicators, the fire hazard of the sample is evaluated.

Prev: Operation steps of G184 shoe flex tester