Erythema effect tester

Erythema effect tester

The erythema effect tester is mainly used for testing effective UVR reading instruments, crawler bulbs, and sterilization instruments for erythema. It can be used to test the output of lamp tubes/sunlight, acrylic transmission, and UV resistant eyes, and has a wide range of application fields.

Silicon carbide (SiC) photodiodes are airtight sealed in a sealed container with only a UV glass window cover. Thus, the interference filter blocks the response above the ultraviolet erythema, as shown in the spectral sensitivity map.
​​​​​​​

Product operation:

Press and hold the switch button on the front of the solar radiometer. Align the sensor section at the top of the panel directly with the ultraviolet light source. For a tanning bed, place the instrument on the body and the reading will be displayed on the LCD. If necessary, the reading can be recorded.

During operation, the battery voltage is between 9V-6.5V. When the voltage is below 6.5V, the LCD reading will start to blur, and the battery needs to be replaced. In "typical" mode, the battery can be used for about 2 years.

Product features:

This instrument contains an integrated sensor, which is easy to operate and durable. The test reading is accurate, and the data can be directly displayed on the LCD

Technical parameters:

Radiation range: 19.99 W/m2

Response: 280-400 nm Differy Erythermal Action Spectrum

Resolution: 0.01 W/m2

Update speed: 3.0 Readings/Sec

Display: 3.5 Digital LCD

Number size: 0.4 inch high

Operating temperature: 32 ° F to 100 ° F

Operating humidity: 5% to 80% RH

Accuracy: ± 10% REF.NIST

Dimensions: 4.2L x 2.4W x 0.9D (in.)

Weight: 4.5 OZ. (included. bat.)

Power supply: 9-Volt DC Battery

Lens: UV Glass

Diffuser: Teflon

Detector: SIC/IF Photodiode

Prev: Simple porosity meter