Welcome to the Qinsun Instruments Co., LTD! Set to the home page | Collect this site
The service hotline

Search


Related Articles

Product Photo

Contact Us

Qinsun Instruments Co., LTD!
Address:NO.258 Banting Road., Jiuting Town, Songjiang District, Shanghai
Tel:021-67801892
Phone:13671843966
E-mail:info@standard-groups.com
Web:http://www.qinsun-lab.com

Your location: Home > Related Articles > Test Operation of Bed Covers Flammability Tester أداة الاختبار –

Test Operation of Bed Covers Flammability Tester أداة الاختبار –

Author:QINSUN Released in:2023-10 Click:52

The bed cover flammability tester is a testing equipment independently developed and produced by qisnun Precision Electromechanical Technology Co., Ltd. It conforms to relevant ASTM D4151 testing standards and is used to test the flame retardant properties of plush fabrics such as bed. blankets. Ignite the sample and test paper mounted on the sample holder with a standard flame for 1 second to complete the test. Specimens are evaluated by observing changes in the test paper.

Test principle:

Within the specified time, the surface of the sample is burned with a standardized flame, so as to observe the combustion, damage or discoloration of the paper standard test, then perform the test. Fabrics are classified.

Main parameters:

1. No. 18 needle flame, flame length is adjustable;

2. The ignition time can be adjusted freely, withec a high degree of automation;

3. Automatic timing, timing accuracy 0.1s;

4. Flow meter range: 0 ~ 60 cc/min;

5. Equipped of a butane tank for gas supply device without the need for a large gas tank or reservoir.

Operation steps:

1. Place the assembled and dried sample (sample holder) on the sample support.

Tip: If the sample has been pretreated, the test operation should be started at this time. The standard states that the test must be started within 30 seconds of removing the sample from the desiccator.

2. Turn on the main power of the instrument to the on state. Set the ignition time on the timer to 1 s and start the test.

Turn on the instrument start button to start the instrument. The burner ignites and the impact of the flame begins. At the same timeme time, the timer starts automatically. Continuously test 5 samples (front or back) and perform subsequent tests after the other 5 samples are dried.

Tips: Before testing, make sure the sample has been properly installed on the test bench and the automatic flame impact time has been set to 1s.

As an enterprise integrating R&D, manufacturing, sales, training and service, Shanghai Fanbiao Textile Testing Technology Co., Ltd. is committed to continuously providing more testing instruments to the market and providing textiles, long-term testing. instruments for leather, combustion, automobile interior materials, environmental climate aging, masks and protective clothing, etc. can also accept non-standard customization. Targeted testing can be carried out according to customer requirements before purchase to ensure that thepurchased instruments are applicable.

Prev:

Next: