Glass polarization tester

Product introduction

Product use: mainly used to observe whether the left and right polaroid lenses (polarizers) are parallel symmetry

Based on the standard:

The design standard of this instrument complies with EN1836, EN172, QB2659: 2004, GB10810.3: 2006, QB2659: 2004, ANSIZ80. 3, AS/NZS 1067 Etc.

Technical parameters:

Parameter type

Technical specifications

Model

FLR-Y01 Polarized Glasses Tester

Reading Button

-30-+30°

Minimum Reading Value

1°

p>Light source

Sodium lamp (589nm)

Dimensions

27×37×34CM (L×W×H)

p> Weight

Weight

p>

10kg

Input voltage

AC100～240V50/60Hz

Product benefits

This product can replace the Italian LEMAPA1 product

How to use

1. Connect the right power supply and turn on the power switch;

2. Confirmthe glasses needed for testing Position: This is the position of two plastic-steel fixtures at the top and bottom in front of the light source. This fixture can adjust its angle. The angle must be adjusted to the curvature of the frame. The adjustment should be parallel to the two light sources, and the distance between the front and back of the two eyes should be the same; p>

3. After attaching the test goggles, the tester checks whether the brightness of the upper semicircle and the lower semicircle of the test light source are the same from the rectangular observation hole directly above the front of the machine; brightness is the same, then look at how many degrees each of the two hands point above the light source, that is the result of the test.

Prev: FLR-S02 Reflectance Tester with anti-reflective coating for lenses