The taber wear resistance testing machine is mainly used to test the wear resistance properties of materials. By means of rotary grinding, different types of friction wheels are used to rotate and rub samples to test the wear resistance properties of leather and plastic materials. This is our company qisnun The test equipment independently developed and produced by Precision Electromechanical Technology Co., Ltd. has high cost performance and comprehensive after-sales service.
Main parameters:
1. Test piece: outer diameter 108mm, inner diameter 8mm, 3mm (D)
2. Grinding wheel: diameter 2\"( M *45mm)1/2\"(W)
3. Center distance of grinding wheel: 63.5mm
4. Center distance of grinding wheel and disc test: 37~38mm
5. Rotation speed: 60/72 rpm
6. Weight: 250g, 500g, 1000g
7. Counter: LCD, 0~999.999
Experimental operation:
Clamp the sample
Place the cut sample on the test bench according to the higher standard requirements.
Hold the specimen flat, tighten the compression nut and gasket, then tighten the specimen clamp ring with a hex wrench.
Tightening the wear wheel and weight
Install the pre-ground standard wear wheel on the front inner side of the balance arm and tighten the nut. compression.
Tighten the corresponding weight or balance weight according to the required pressure.
According to the specifications of the abrasive wheels tested for different materials in the corresponding standards, install the abrasive wheels of the corresponding specifications.
Start
Turn on the power switch.
Set a predefined number of revolutions on the counter.
Press the start button, the motor drives the turntableto start spinning.
Note:
1. When the grinding wheel is worn on the surface of the sticker or the grinding wheel is uneven, it should be replaced.
2. Before each sample is measured, the grinding wheel should be cleaned with a brush.
As an enterprise integrating R&D, manufacturing, sales, training and service, Shanghai Fanbiao Textile Testing Technology Co., Ltd. is committed to providing more test instruments to the market, long-term supply of textile, leather, combustion test instruments, automotive interior materials, environmental weather aging, masks and protective clothing, etc., can also accept non-standard customization. Before purchase, we can carry out targeted tests according to customer requirements to ensure that the instruments purchased are suitable.
Prev: Experiment of testing pilling performance by circular track method
Next: Rotation Speed and Cone Angle of Schober Abrasion Tester