Clark Pump KF0/0.5S10KP0AODL2/107 installation steps

POWER-pump KF0/0.5S10KP0AODL2/107 installation steps and methods:

1. Clamp the pump with a vise, with the drive shaft pointing down, and install it on the flange.

2. Draw a line on each casting in deassembly. This ensures proper alignment during reassembly.

3. If the pump has a keyed shaft, remove the key from the drive gear. Carefully grind away any burrs on the shaft to prevent damage to the shaft. seal.

4. Remove all bolts and washers from the assembly.

5. Remove the rear port cover.

POWER pump KF0/0.5S10KP0AODL2/ 107

6. Remove the pressure plate by hand. Do not pry. The channel seal can be stitched onto the Groove in the board.

7. Carefully remove the gears from the gearbox. Keep the gears together as it is a matching set.

8. Carefully remove the second pressure plate from the surface of the shaft end cover by hand. Hold the channel in the pressure plate groove Center Seal .

9. Lift the gearbox off the shaft end cover. Hold the gasket seal in the gear groove.

POWER pump KF0/0.5 S10KP0AODL2/107Delivery from Germany

AVENTICS valve R431003041
BAUMER encoder EIL580-TN10.5$N.01024.A/ 11129636
MAGTROL brake 005253HB-20M-2
SUNControlAnalytik filter ABS2003
SUNControlAnalytik filter element SF2013
SUNControlAnalytik separator KVE
Flutec throttle valve 705365DVP-30-01.1
HYDAC sensor AS3008-5-000
HYDAC Level meter FSK-127- 2.5/C/-/12,3112276
Engler sensor PT100-6.12.12M.52.STG102028
elringklinger seal RWDRHN239035X50X807790320ET0001
PQS solenoid valve RSE4-062R11/ 024S-L -1
TIVAL pressure switch 1010096FF4-8DAHG
Biotech flow meter 97479540, VZS005-PP
E+H level meter FTL33-2RR8/0FTL33-AA1U3BB3CJ??
E+H liquid level meter FTL33-2RR8/0FTL33-AA1U3BB3CJ? ?
REXROTH controller R911310462HMS01.1N-W0110-A-07-NNNN
HOFMANN vibration sensor PMG81EA
GEFRAN sensor F018627TR1-C -2-B-1 -A-H-D-2050X000X00100XX
REXROTH CONTROLLER R911173004CML75.1-3P-900-NA-NNNN-NW
AVENTICS cylinder#5226639710?MNI-DA-025-0100-663971-MODI
BAUMER sensor OADM20U2472 /S14C11077736
BAUMER encoder 11167544HS35F01024HABZCC024BE1007T5
BAUMER encoder EIL580-TT15.5FE.00360.A-11118501

Prev: Introduction, installation requirements and precautions of differential pressure transmitter