Chrysler low-temperature bending tester

Chrysler low-temperature bending tester

Compliant with standards: Chrysler LP-463LB-9-01, Chrysler LP-463KB-113-01, Chrysler LP-463KB-10-01

Applicable scope:

The Chrysler bending tester is designed to test the adhesion of coating materials on the substrate through bending and folding, i.e. the mechanical stability of the coating. Design based on Chrysler Laboratory Test Method LP-463LB-9-01. This experiment characterizes the adhesion of coating materials on substrates of vinyl coated fabrics and leather. It can also test the cracking, whitening, cracking, and layer separation of vinyl coated fabrics, leather, unsupported vinyl, and other soft decorative materials.

Product details:

The tester can test four samples at once, including three bent samples and one folded sample. When the bent specimen is clamped at both ends by the fixture and tightened, one end remains fixed and the other end moves horizontally, the bending test can be conducted. Clamp the two ends of the folded specimen close to each other between two opposite flat plates, and apply a 12lb load to the folded area. Close the tablet to apply the corresponding pressure.

Bend the specimen and tighten it with a fixed weight. The tension must be controlled.

Structural features:

1. Power supply, start and stop switches

2. Power device: motor

3. Motion device: reduction gear, connecting rod, moving crossbeam

4. Counting device: Counter - displays the number of working times

5. Bending test device and folding test device

6. Tension adjustment device: spring, pressure plate - folding process; Arm and weight - bending process

Technical parameters:

1. Desktop computer;

2. Bending test station: 3 stations;

3. Folding test station: 1 station;

4. Each sample gripper can clamp and provide tension to the sample separately;

5. Working stroke of connecting rod: 70mm (2.75in.);

6. Clamp spacing: 152mm (6in.);

7. Working frequency: 35 times/min;

8. Bending test load: 36N (8lbf.) per specimen, adjustable;

9. Folding test load: 641N (12lbf.) after closing;

10. Sample size for bending test: 76 x 203mm (3 x 8in.);

11. Folding test sample size: 129 x 129mm (5 x 5in.);

12. Equipped with electronic counters that can be manually reset;

13. Electronic counter: 6-digit number;

14. Boundary dimensions: 36 x 12 x 20 (length x width x height).

Prev: Wool fineness analyzer