What is the installation method of taber5135 abrasive tester grinding wheel? This is the case

Product Introduction

What is the installation method of taber5135 abrasive tester grinding wheel? The grinding wheels of the taber 5135 abrasion tester are divided into elastic grinding wheels and rigid grinding wheels, which are packed in pairs in a tight package. When the grinding wheel is not in use, please place it in a special airtight container to prevent deterioration and damage. Therefore, everyone should be clear about the installation and disassembly work. Below, Shanghai Qianshi will bring you relevant introductions.

Install the grindstones:

One is marked "Left Hand This Side Out", the left hand takes it out from this side, the other is marked "Left Hand This Side Out", right hand Take the letters from this side. The purpose of this instruction is to ensure that the grinding wheel and the mounting punloading position in the container from the next use is consistent.

To install a grinding wheel, remove the knurled nut marked with the arrow on the nut from the grinding wheel shaft. The nut on the left side of the grinding head is a left-handed nut, remove it clockwise, and the nut on the right side of the grinding head is a right-handed nut, please remove it counterclockwise.

Clean any fine particles lodged in the grinding wheel shaft and flange to prevent deflection of the grinding wheel. Loosen the grinding wheel, slide it carefully onto the shaft and tighten it hand tight.

If you notice that there is a grinding wheel that vibrates after turning it lightly with your fingers, remove it, check and clean the small foreign objects attached to the shaft and reinstall it. If the elastic grinding wheel vibrates slightly after mounting, you can place it on the positioning guide with your fingersof printing.

If you tTo remove the grinding wheel with your fingers and find deviations such as radial eccentricity in the bearing, you need to use a 200 type polishing wheel to polish again.

Loading the grinding wheel:

The gravity specification of the grinding wheel on the sample is usually specified in the standard specification. Usually there are three standard ranges to choose from, 250 grams, 500 grams or 1000 grams. If you must work in an environment with less than 250 grams of gravity, use a balance lever and a grinding wheel weight. When it works under the gravity environment of 250 grams, it is not necessary to add any weight except the grinding arm and grinding wheel. This weight is stamped on the wheel mounting kit box.

If you need to work in a 500 gram gravity environment, slide the weight slide marked 500 gram over the protruding top of the grindstone bearing set. The stated weightindicates the combined weight of the weight and arm.

If you need to work in a 1000 gram gravity environment, slide the weight slide marked 1000 grams to the grinding wheel bearing set.

Prev: Little knowledge of Taber Abraser معدات اختبار