Rotational speed and cone angle of Schober wear meter

The Schober Abrasion Tester uses rotational abrasion to test for changes in appearance of fabric samples after friction or wear testing. It is mainly used for testing automobile interior materials. During the test, friction is applied to the rotating sample in the tangential direction through the friction component to measure the wear resistance of the sample. This is testing equipment independently developed and produced by our company, Qisnun Precision Mechanical and Electrical Technology Co., Ltd.

Complies with standards:

DIN 53863 part 2, GME 60345 standard, GMW 3283 standard, VW/Audi PV3908

Main parameters:

1. Rotation speed: 75R/min;

2. Cone angle: 166°;

3. Tilt angle of test head holder: 7°;

4. Sample size: 100 cm2;

5. Test area: 50 cm2;

6. Highly adjustable sample arc, equipped with measuring accessories, measuring range 0~10mm;

7. Sample pressure: 0.5N ~ 25N adjustable;

8. A set of load weights: 50g, 100g, 250g, 500g, 1000g, 1500g.

Operation steps:

1. Install the temperature and humidity treated sample with attached accessories on the sample holder to form a rotating test head and adjust it according to standards or other requirements The protruding height of the test head is generally 5-8mm;

2. Install the test head with sample on the test head installation plate on the instrument workbench, and use the locating pin on the installation plate to install and tighten the test head in conjunction with the locating hole below. the test head;

3. Use the friction device located on the pressure plate of the instrument to iInstall the friction sandpaper on the bottom surface of the pressure plate and lock it. The clamp ensures the sandpaper is tight and installed flat;

4. Manually pull the pressure plate lifting lock located on the right side of the pressure plate outward, lower the pressure plate and put the sandpaper in contact with the surface of the sample on the test head;

5. Install a weight of corresponding weight on the weight shaft above the pressure plate so that it exerts some pressure on the friction of the sample. The required pressure value is selected based on the weight of the sample per unit area.

Shanghai Fanbiao Textile Testing Technology Co., Ltd., as an enterprise integrating R&D, manufacturing, sales, training and service, is committed to putting more testing instruments on the market and to provide long-term textiles, leather, combustion testing instruments, automobile interior materials, environmental climate aging, masks and protective clothing, etc. can also be customized to meet non-standard requirements. Targeted testing can be carried out according to customer requirements before purchase to ensure that the purchased instruments are suitable.

Prev: experimental operation of Taber wear resistance testing machine