The hydraulic oil flows into the IN port through the directional control valve CV, flows directly through the check valves KV1KV2 and DV, and reaches the high pressure side H In this case, the current through the amplifier will be at its maximum, enabling the fast-forward function. When the pump pressure on the high pressure side H reaches a predetermined value, the valvesKV1, KV2 and DV closed. The final pressure is obtained by the reciprocating movement of the oil pump OP. When the final pressure of the high pressure side H reaches a predetermined value, the equipment automatically stops running. The final pressure is obtained by the reciprocating movement of the oil pump unit OP. When the final pressure of the high pressure side H reaches a predetermined value, the equipment automatically stops. If the pressure on the high pressure side drops due to oil consumption or leakage, the OP valve will automatically operate to maintain the final pressure.
Detailed parameters
PIN:20 to 200 bar (inlet pressure)
PH: max 800 bar (outlet pressure)
PRETURN: As low as possible (to the Backpressure)
Boost ratio: PH= (PIN– PReturn) i (boost)
Installation: Pipeline
Accessory: control flap
Type A = without check valve
Type B = with check valve
Type G = Direct proportional control
MINIBOOSTER supercharger HC4 component
HC4 adapter board HC4- NG10-1
HC4 center liner MBHC4-KIT-1
Prev: The difference between ATOS proportional valve and servo valve
Next: Tianjin Bunsen Reveals the Secret: Summary of Fetal Bovine Serum Pre-sale Issues