Main application:
Drum wear tester/roller wear tester is mainly used for testing rubber, tires, shoe soles, elastic materials, conveyor belts, soft synthetic leather and others materials wear resistance.
Main features:
1. Small sample, time saving, low noise, high efficiency;
2. The friction path is not repeated;
3. Good reproducibility and easy operation.
Main parameters of the drum wear tester/roller abrasion testing machine:
1. Test piece: φ16mm, 6~15mm (D)
2. Luminaire load: 2.5N
3. Weight load: 2.5N, 5N
4. Abrasive cloth: 60#
5. Roll diameter: 150mm; Roll length: 460 mm; Roller speed: 40 rpm
6. Planned stroke: 40m/20m
7. Sanding speed: 0.32m/sec
8. The angle of inclination is 3°: the support shaft of the test piece is clamped with the vertical surface of the roll angle
9. The silkiengse displacement of armature: 4.2mm/roll per circle
Comply with standard:
DIN 53516, JIS K6369 , GB/T 8.3 of 20991, GB 20265-2006, GB20266-2006, SATRA TM174, BS 903, JIS K6264, GB/T9867, ISO4649
Detection principle:
Under a certain load, at a certain level of mesh, the columnar sample is transversely cut and ground on the surface of the mesh for a certain impact, by measuring the mass abrasion of the sample, and then calculating the volume of wear by the density of the sample, to determine the To make the test comparable, standard rubber should be used at the end and the test result is expressed as the relative volume abrasion based on the calibrated mesh or abrasion resistance basis expressed as the abrasion against a given standard rubber.
Service Guarantee:
1. Outside the warranty period, our technical staff will not be lessthan return three times a year to examine user usage;
2. Service principle: fast, decisive, accurate, considerate and professional;
3. Service purpose: service quality to win customer satisfaction;
4. Service efficiency: if the equipment fails within the warranty period or outside the warranty period, the supplier will provide a solution within 24 hours after receiving the report.